Change levers

Great British Handcrafted Motorcycles › Forums › CCM Motorcycles – General Discussion › Change levers

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 13 July, 2020 at 11:24 am #5476
    Chocolate Rat
    Member

    Hi all, has anyone got any simple instructions on how to change the levers to the billeted ones? The clutch seems very different to the ones I have done in the past primarily because it’s not a cable one. There seems to be oil coming from the little threaded bolt so my hesitation is based on the fact I don’t want to render it unrideable if I make a daft mistake (which has been known).

    Any advice would be gratefully received.

    14 July, 2020 at 9:27 am #5487
    Chocolate Rat
    Member

    Update: The removal of the clutch lever is simple although I had to be carefull not to lose the flying springs. The one bit that is still beating me is the removal of the piston from the stock lever. The little black plastic bolt head will tighten or loosen but I can’t seem to remove it and thus remove the wider cylindrical metal pin. Not sure if that makes sense but if it does and someone in the know is reading this then any hints would be great.

    17 July, 2020 at 8:56 am #5568
    John Drogan
    Staff

    Hi. The screw part you refer to needs to be pulled off from the lever whi8ch will then allow the pushrod to be removed. Good luck! 🙂

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.