Reply To: CCM fob…. What’s the trick?
Hi Mel,
This might be a silly question,(I apologise in advance for asking) but did you see the fob work before you brought it home ?
Where about is the sensor on the cafe racer, by the back seat or on the side ? I think on the older bikes it’s at the back seat. On my Six it’s on the side.
There are some pictures in the handbook that come with the bike. You should be able to download from this site, I think it’s under the servicing tab.
Did you get the master fob, in=case you need to reset your operating fob ?
If so :
WHAT IS THE RED KEYFOB FOR?
The red master key fob has one sole use – to program new ignition key fobs. You should never attempt to start the bike using the red master key as this will automatically start the pairing mode and the only way to start the bike is to complete the pairing process as follows;
Introduce the red master key fob to the sensor on the bike. (Please refer to your handbook to establish the correct location on your bike) The dashboard will illuminate for approximately a tenth of a second and the fuel pump can be heard briefly.
Keeping the fobs separate, introduce the silver CCM fob – the same sequence will occur as in step 1 (If you have more than one and up to 3 ignition fobs, repeat this step for each new fob)
Re-introduce the red master fob – this time the dashboard/ headlight/ taillights will illuminate for a full second and the fuel pump will also deploy.
You can now use any of the silver key fobs that you have just programmed, and the ignition will now switch on and remain on until you re-introduce the silver fob to switch off.
Hope this helps. Good luck
